Low profile 1/4 jacks for patch leads?

Hapijoel

Hi there,

So I've started making up my own cables for my pedal board - finally time to finish the job.

My issue is, I'm using a Wounded Paw Blender v4, basically a 4 channel mixer, which has a gang of inputs on the back fairly tight together. I've been using Switchcraft pancake right-angle plugs, but they're too fat to fit side-by-side for each of the channels inputs and outputs.

Anyone know of some fairly low profile straight plugs I could use to solve this over crowding problem?

thanks!

Winny_Pooh

Evidence Audio solderless

rossyamaha

About as low profile as it gets. 

https://www.designacable.com/sp400-squareplug-world-s-smallest-angled-1-4-mono-jack-pancake-plug-connector.html

Gagaryn

rossyamaha said:

About as low profile as it gets. 

https://www.designacable.com/sp400-squareplug-world-s-smallest-angled-1-4-mono-jack-pancake-plug-connector.html

Not seen those before, they look great. :-)

PhilKing

Lava cable make some really small ones too https://lavacable.com/collections/plugs/products/lava-min-plug-solder-free

Hapijoel

Thanks guys!

Anyone know if you can still solder the solder-free plugs? Just to make them more hard wearing

Hapijoel

rossyamaha said:

About as low profile as it gets. 

https://www.designacable.com/sp400-squareplug-world-s-smallest-angled-1-4-mono-jack-pancake-plug-connector.html

Might have to check those out!

Hapijoel

Actually just found these, thanks!

https://www.designacable.com/switchcraft-380-straight-mono-stumpy-jack-plug-connector.html