So I’m sure I know the answer, however…
I’ve just gone to do a neck swap in my partscaster and when I’m, the nuts way too low. Neck pocket was probably much deeper on whatever it had before, or maybe it was always buggered.
So, the frets are kinda low, fair amount of sprouting (which I’ve tamed a bit), so at some point I see it getting a refret anyway. So are those cheap ass nut files off Amazon suitable for even a rough amateur job? I’ve never replaced a nut before.
Also how will I know if I need a flat bottomed or radiused nut? Will it matter, or would I have to do it myself anyway?
Feel free to start the slaying now!
Comments
if I were to get a bone nut, would I need a radiusing block to get the nut underside curved corrrctly?
thanks for your help @BillDL