FS **Kingsley Pedals FINAL PRICE DROP** ALL SOLD

Hootsmon

B is for bump

Hootsmon

Further Price reduce bump!!!

Hootsmon

2nd price reduction!

Serf reduced to £325 posted............................£50   off OP

Jester Custom reduced to £599 posted..........£100 off OP

Hootsmon

Step Right Up....

Hootsmon

...........

Hootsmon

Deputae Dawg

Hootsmon

Yogi Bear

Hootsmon

Casper

Hootsmon

Top Cat

Hootsmon

Snagglepuss

Hootsmon

Yogi Bear

Hootsmon

Casper

Hootsmon

Bump

Hootsmon

.....

Hootsmon

snow

Hootsmon

Serf left

Hootsmon

SERF boost yours posted PPG now @ £300

Hootsmon

The Serf is a hand-wired valve (tube) boost pedal, utilizing a 12ax7 tube running at high voltage. 
A 12ax7 tube contains two gain stages. In the Serf the first gain stage is a voltage amplifier and boosts the guitar's signal, while the second stage is wired as a DC coupled cathode follower, providing a low impedance output.

Suitable for general boosting duities, the Serf also excells at pushing amps and OD pedals into higher gain. The Serf Boost is a clean boost - it does not clip easily itself (as opposed to the Kingsley Page Tube Boost for example, which breaks up on it's own as the Gain control is raised). The Serf is also our smallest vacuum tube pedal.
Applications for the Serf include:

A full range volume or solo boost (typically placed after any gain pedals);
A bright boost - to liven a dark sounding amp, or even for use as a very simple preamp;
A boost for pushing OD pedals and amp's harder, providing increased overdrive/saturation;
A valve buffer and tonal enhancer (when the pedal is turned on).

As with our other tube pedals, an internal DC to DC converter power supply provides the Serf's Tungsol re-issue 12ax7 with the appropriate high voltage for optimum performance, while a 6VDC output powers the tube's heaters. 

The Serf couldn't be easier to operate. A single Volume control sets the amount of boost, while a 3-way Mode switch gives options for:

Mode 1 - full range boost
Mode 2 - bright boost 
Mode 3 - added output with a low end roll-off

For those who are familiar with the Kingsley Jester's boost, the Serf is quite similar. However, Mode 2 on the Serf is brighter and Mode 3 is just a touch leaner, making it excellent for pushing pedals and amps harder, while retaining low end definition. The Jester Boost also does not have the cathode follower output stage.

Measurements: 3 1/4" wide x 4" deep x 2.56" tall

Power requirements: 9VDC @ 500mA, center negative, 2.1mm jack

Hootsmon

Schmeggy

Hootsmon

SSSSSSSSSSSSSSSSSSSSSSSSSSSSSSSSSSSSSSSSerf