It looks like you're new here. If you want to get involved, click one of these buttons!
Subscribe to our Patreon, and get image uploads with no ads on the site!
Base theme by DesignModo & ported to Powered by Vanilla by Chris Ireland, modified by the "theFB" team.
Comments
is it crazy how saying sentences backwards creates backwards sentences saying how crazy it is?
I think that a standard barrel connector is 5.5mm x 2.1mm.
I have measured the outer diameter of my barrel at 5.5mm but have no way of measuring the inner but I am given to believe that it is bigger than 2.1mm ?
I've just checked the plug, and it measures around about 2.5mm. Certainly a 2.4mm drill bit slides in with a bit wiggle room, but a 2.6 doesn't fit in. I would try a 2.5mm, but I couldn't find one.
A quick search suggests 2.5mm pin size is reasonably common
@timmysoft the wall sockets I want to use are under a wall unit & assuming there was enough spare cable in them to flip them, which I doubt, it would still mean that I couldn"t use it as there is just not the clearance between the socket & unit.
It is the ideal location to plug into as it means that the TT can permanently sit on top of the unit underneath the wall unit.
Obviously an extension cable could be used but I am trying for the neatest least obtrusive solution so that Mrs baldy will allow me to keep the TT permanently on the unit in the living room as at the moment it has had t be put away in a cupboard.
I have raised a support ticket with Line 6 so hopefully they will be in contact in the next few days & confirm the barrel size so that I can either buy a different shaped/sized PSU with the correct barrel or fit a new barrel to a PSU that will fit the space.
That would mean that the centre pin would have to be under 2mm, probably 1.7mm or 1.8mm to allow it to fit.
My barrel is is definitely 5.5mm OD as it measures 2.40mm on my digital calipers so will be a 5.5mm barrel ?
The closest I can measure the ID is that it is definitely over 2mm but could be anywhere between 2.1mm & 2.5mm as my calipers wont actually fit in the hole properly to measure accurately.
I have no idea where Line 6 are getting these measurements from ?
is it crazy how saying sentences backwards creates backwards sentences saying how crazy it is?
If their measurement of 2mm is of the actual pin diameter as opposed to the ID of the barrel I could understand as a 2mm pin would need a barrel with a centre hole slightly larger than that to allow it to fit but their 5mm OD measurement is weird as it is definitely not the barrel OD but also cannot be the ID size of the hole in the back of the TT unit.
I am going to just buy a PSU with a barrel connector that is 5.5mm OD & 2.5mm ID & hope that it fits.
If that doesn"t fit I guess that it must be 5.5mm x 2.1mm.