It looks like you're new here. If you want to get involved, click one of these buttons!
Subscribe to our Patreon, and get image uploads with no ads on the site!
Base theme by DesignModo & ported to Powered by Vanilla by Chris Ireland, modified by the "theFB" team.
Comments
if you drill out the center of the dot it should be easy to remove the rest. be aware some dots are deeper than others.. Warmoth plastic dots seem to go most of the way through the board, most are only a couple of mm
Then install the new ones as flush with the surface as possible to minimize cleanup. you may still need to file and scrape the board afterwards to level off between the frets. This is a bit fiddly, but not too bad with simple dots
Instagram