It looks like you're new here. If you want to get involved, click one of these buttons!
Subscribe to our Patreon, and get image uploads with no ads on the site!
Base theme by DesignModo & ported to Powered by Vanilla by Chris Ireland, modified by the "theFB" team.
Comments
ta v m
https://www.thefretboard.co.uk/discussion/262673/
There's a QR code to it in the package, and it's also pinned to the top of the FX section just in case
Thanks Jon
PM incoming shortly.
I did want to make a larger kit, but that runs into a bit of a problem in that while I can print one of them fairly easily, there's no way to economically print them in bulk because my printer simply isn't large enough to fit more than one piece on the build plate at a time. I have trust issues with the manufacturers of the only larger printers on the market, so I'm stuck waiting for Bambu to stop faffing around making smaller/cheaper printers and actually get round to making the one thing that everybody's been screaming for since the beginning - a 300-350mm square printer.
I've since discovered that I may be able to make it work so that it takes two build plates to do a single kit. However, that doesn't mean much because my extruder and hot end have given up the ghost.
New (vastly upgraded) hot end's just arrived and I've stripped and rebuilt the extruder, replaced the heater and thermistor...and I'm just trying to get the thing back up and running at the moment - currently swimming through error codes, so I might be replacing some wiring at some point this evening.
However, if this all works, I should be able to print almost twice as fast, which means the increased effort of printing two plates per kit might not actually hurt that much.
Then I just need to figure out if I can actually design a larger board that'll fit within the constraints.