Finished this £10 eBay neck (or did I?) today. It went better than my first attempt that's for sure but am wondering is this a good enough job with some crowning and a Polish. I have levelled it and it didn't need a lot. Some very slight moment on the fret rocker (about 6 frets in total) but I do mean very slight. I can see why it's expensive, it's not the tap it in and done job I used to think it was. Some bits just won't tap down any further and I just had to level that bit out. Not having all the tools I rounded the edges with a box file (taped one side) I think I overdid them but can't put it back now.
http://i64.tinypic.com/15yw12a.jpg
Comments
Instagram
I put wood blocks under the table so its fully supported. I alwasy intended to buy a proper press, but have never needed to
Instagram
Instagram