I'm trying to set up an footswitch triggered A/ B split where the B path goes to my overdrive pedal via fx send/return then back in to a HX noise gate and then rejoins the A path. I've got the split point assigned to a footswitch and it routed to B100 so that the A path is (I think) muted until the B path rejoins it.
The problem I have is I seem to be getting bleed through from the A path when switched to the B path, e.g. If I stick an FX pedal on the A path immediately after the A/B split I can hear that fx when switched to the B path.
Am I just not understanding how the split and footswitch routing works or is this an issue with the HX firmware?
I hope this makes sense (?)
(pronounced: equal-sequel) "I suffered for my art.. now it's your turn"
Comments
Could you add a gain block to the A path just before the rejoin? Set it to minus infinity/mute if it is supported and switch it with the other blocks? I'm not saying that is how it should be but it might get you where you want to end up.
You might need to change the split type.