The BBQ Thread.

What's Hot
12325272829

Comments

  • WezVWezV Frets: 16965
    I'm using the most basic and cheap  offset smoker to do a brisket and some ribs today.  Then an old half barrel BBQ later for chicken, lamb etc

    Given its not a fancy piece of kit I will be spending the whole day very closely monitoring the temperature of the smoker.   Thankfully the weather is on my side and its holding well so far.  Last time I used it was a windy day, which made it totally useless.
    0reaction image LOL 0reaction image Wow! 1reaction image Wisdom
  • fretmeisterfretmeister Frets: 24868
    Yeah, cheap offsets are crap. I had one. 2mm steel. No temp control.
    Massive variation in temps in the chamber.

    Got rid a long time ago.

    You can improve it by using a fireproof aluminium based insulation blanket but if you spend that money you might as well buy a WSM.

    I’m so bored I might as well be listening to Pink Floyd


    0reaction image LOL 0reaction image Wow! 0reaction image Wisdom
  • WezVWezV Frets: 16965
    Yeah, the temp is inconsistent.   It's not done too bad so far, just a lot of work maintaing temp and shuffling bits round every so often.


    Few more hours to go and everything is going well
    0reaction image LOL 0reaction image Wow! 0reaction image Wisdom
  • bertiebertie Frets: 13578
    Neilybob said:
    Smoked 3kgs of pork butts (shoulder) yesterday for 10 hours. Used American mustard and Bart's smokey BBQ rub. Fell apart like butter. 



    That is all. 
    butter doesnt fall apart  ;)

    what did it play like tho ? 
    just because you don't, doesn't mean you can't
     just because you do, doesn't mean you should.
    0reaction image LOL 0reaction image Wow! 0reaction image Wisdom
  • DiscoStuDiscoStu Frets: 5602
    So what am I doing wrong, guys?
    I've got a 57cm kettle BBQ (not a Weber) with a vented ash catcher but I'm struggling to maintain the heat.
    Yesterday I used two chimneys of briquettes and when I initially closed the lid (with bottom vent fully open) it shot up to 300C, but after I opened it again and put the burgers on it it dropped down to 130/150C even with the lid back on and bottom vent open and never regained the initial temperature.
    Do I need to use even more briquettes? I thought two chimneys' worth was plenty. I had them evenly spread over the grate rather than piled on one side.

    0reaction image LOL 0reaction image Wow! 0reaction image Wisdom
  • bertiebertie Frets: 13578
    you need to suck on the chimneys
    just because you don't, doesn't mean you can't
     just because you do, doesn't mean you should.
    0reaction image LOL 0reaction image Wow! 0reaction image Wisdom
  • fretmeisterfretmeister Frets: 24868
    DiscoStu said:
    So what am I doing wrong, guys?
    I've got a 57cm kettle BBQ (not a Weber) with a vented ash catcher but I'm struggling to maintain the heat.
    Yesterday I used two chimneys of briquettes and when I initially closed the lid (with bottom vent fully open) it shot up to 300C, but after I opened it again and put the burgers on it it dropped down to 130/150C even with the lid back on and bottom vent open and never regained the initial temperature.
    Do I need to use even more briquettes? I thought two chimneys' worth was plenty. I had them evenly spread over the grate rather than piled on one side.

    When it went up to 300C you basically used all your fuel up and it couldn't get as hot anymore.
    You really don't need 300C / 572F for anything!
    If you spread the coals wide and thin you make it worse because they get all the air in the world. 

    Are you cooking on a grate or on a solid surface in there?

    I’m so bored I might as well be listening to Pink Floyd


    0reaction image LOL 0reaction image Wow! 0reaction image Wisdom
  • DiscoStuDiscoStu Frets: 5602
    DiscoStu said:
    So what am I doing wrong, guys?
    I've got a 57cm kettle BBQ (not a Weber) with a vented ash catcher but I'm struggling to maintain the heat.
    Yesterday I used two chimneys of briquettes and when I initially closed the lid (with bottom vent fully open) it shot up to 300C, but after I opened it again and put the burgers on it it dropped down to 130/150C even with the lid back on and bottom vent open and never regained the initial temperature.
    Do I need to use even more briquettes? I thought two chimneys' worth was plenty. I had them evenly spread over the grate rather than piled on one side.

    When it went up to 300C you basically used all your fuel up and it couldn't get as hot anymore.
    You really don't need 300C / 572F for anything!
    If you spread the coals wide and thin you make it worse because they get all the air in the world. 

    Are you cooking on a grate or on a solid surface in there?
    I thought plenty air was a good thing? I cook on a grate but it just wasn't hot enough to sear any black lines on the burgers or sausages. I mean everything was cooked and nothing got cremated but it took so much longer than expected and continually lost its heat. I've struggled with this since I got the BBQ. Disposables are hotter!
    0reaction image LOL 0reaction image Wow! 0reaction image Wisdom
  • SimonhSimonh Frets: 1360
    more air means the fuel burns faster, once it is alight you need to restrict the airflow just enough to keep it burning without getting through it too fast.
    0reaction image LOL 0reaction image Wow! 1reaction image Wisdom
  • DiscoStuDiscoStu Frets: 5602
    Ok. So a combination of piling the coal rather than spreading it out and tweaking the bottom vent then?
    I'm determined to crack this! If not, we're going gas.
    0reaction image LOL 0reaction image Wow! 0reaction image Wisdom
  • fretmeisterfretmeister Frets: 24868
    If the meat is directly over the hot coals and you are using a grate they will eventually burn or the outside will be just right and the middle undercooked.

    So pile the coals up on 1 side only. a good burger only needs to hit 70C internal temp (adjust for rare etc) so as long as the grill temp is higher than that it will reach it.

    Start the cook over the coals to get a nice charred edge, but then when the burgers are sealed in move them so they aren't directly over the coals and put the lid on.

    That way they get the nice BBQ finish and flavour from the direct heat element, and then continue to cook until ready with the lid on almost in an oven.

    It also helps to control the air flow and increase the cooking time available from the coals.


    The other thing do NOT light all the coals at once. Have about 10-12 lit in the chimney and put them in the middle of unlit ones in the kettle. 10-12 lit coals is plenty to get the heat going and the other coals will light on their own as the heat reaches them. That will keep the heat going longer.

    I’m so bored I might as well be listening to Pink Floyd


    0reaction image LOL 0reaction image Wow! 1reaction image Wisdom
  • fretmeisterfretmeister Frets: 24868
    Go far lower on the air vents than you think. You want it to glow, not actually be on fire. That will just use your fuel up really fast.

    I’m so bored I might as well be listening to Pink Floyd


    0reaction image LOL 0reaction image Wow! 1reaction image Wisdom
  • fretmeisterfretmeister Frets: 24868
    And - doing them properly takes longer than you might think.

    If you want the fastest burger then go gas and use a solid cooking plate. 

    If you want it to have good bbq flavour then doing it slowly is the only way.

    I’m so bored I might as well be listening to Pink Floyd


    0reaction image LOL 0reaction image Wow! 1reaction image Wisdom
  • fretmeisterfretmeister Frets: 24868
    Easy explanation





    ANd a basic - how to set up




    I’m so bored I might as well be listening to Pink Floyd


    0reaction image LOL 0reaction image Wow! 1reaction image Wisdom
  • DiscoStuDiscoStu Frets: 5602
    Cheers @fretmeister I'll need to get this down.
    0reaction image LOL 0reaction image Wow! 1reaction image Wisdom
  • DiscoStuDiscoStu Frets: 5602
    edited June 2022
    This is my BBQ. There is an adjustable airflow vent underneath on the ashcatcher but do you think I should partly cover the hole at the bottom of the kettle at all? I've been leaving the bottom vent fully open, putting the lid on, and keeping the vent on the lid closed.



    0reaction image LOL 0reaction image Wow! 0reaction image Wisdom
  • fretmeisterfretmeister Frets: 24868
    For burgers you are going to be taking the lip on and off so you can have the bottom open just a few millimetres.

    Same for the top. You never want any of them closed completely. Air has to flow.

    I’m so bored I might as well be listening to Pink Floyd


    0reaction image LOL 0reaction image Wow! 0reaction image Wisdom
  • bertiebertie Frets: 13578
    For burgers you are going to be taking the lip on and off so you can have the bottom open just a few millimetres.

    he's not Mick Jagger you know
    just because you don't, doesn't mean you can't
     just because you do, doesn't mean you should.
    0reaction image LOL 0reaction image Wow! 0reaction image Wisdom
  • DiscoStuDiscoStu Frets: 5602
    For burgers you are going to be taking the lip on and off so you can have the bottom open just a few millimetres.

    Same for the top. You never want any of them closed completely. Air has to flow.
    Food for thought. I thought you had to keep the lid vent closed to keep the heat in. I'll try opening it a bit next time and closing the bottom vent more. Cheers!
    0reaction image LOL 0reaction image Wow! 0reaction image Wisdom
  • RobDaviesRobDavies Frets: 3090
    Quick question… are there any other charcoal contenders, other than Weber?

    After a few years on the gas, I'm thinking of going back to charcoal but find the Webers all sit a bit low.
    0reaction image LOL 0reaction image Wow! 0reaction image Wisdom
Sign In or Register to comment.